A gray outdoor condenser/heat pump unit with a side fan grille sits on a concrete pad beside a dark horizontal wood-sided house, with shrubs and a small tree nearby.

Explain it one time

Is a heat pump cheaper to run than gas heat in Oklahoma

Most homes around you heat with gas, so it's a fair question whether your heat pump costs more to run with power priced the way it is here. The answer comes down to your unit and your setup, not a rule that applies to every house. Below, what actually drives that cost, and what a local contractor who installs these year-round would look at in your home before you spend another winter guessing.

Describe it once

A heat pump usually costs less to run than gas heat in Oklahoma, because power here is priced low enough that it offsets what gas heat normally has going for it. A heat pump moves heat instead of burning fuel to make it, so it gets more heat out of each unit of energy than a gas furnace does, and when electricity is cheap that advantage carries through to the bill. Where it changes is cold snaps. When the outside temperature drops far enough, a heat pump has to lean on backup electric heat strips to keep up, and that backup heat costs more to run than the heat pump itself. How often that happens, and how much it adds, depends on your unit's age, its size for your house, and how it was set up. A unit sized and installed right for your home will spend less time leaning on backup heat than one that wasn't.

A woman in a cream sweater with her hair in a bun laughs while seated at a stone counter holding a glass of red wine, in a dimly lit interior with a sofa, houseplants and a large window at night.
A woman with long dark hair in a cream knit sweater laughs while looking off to the side, seated in front of a dimly lit kitchen with an island, stools, open shelving and a potted plant, with a glass of red wine in the foreground.
A smiling woman with long dark wavy hair in a light knit sweater sits at a marble counter with a glass of red wine, with a dimly lit living room and kitchen in the background.
A smiling woman with long wavy brown hair in a beige sweater sits at a white marble counter with a glass of red wine, with a living room, dining table and kitchen cabinets behind her.

Why a heat pump still wins here

A gas furnace turns fuel into heat at close to a one to one rate. A heat pump moves heat from the outside air instead, so it can put out two or three times the heat energy for every unit of power it uses. That difference is what lets cheap power beat gas on the monthly bill. Gas heat has to get much cheaper per unit than electricity for it to come out ahead, and that is not how rates run in Oklahoma. The math only flips if your heat pump is undersized, old, or losing charge, because then it leans on backup electric heat strips that use power at a one to one rate too.

Where the balance can shift

A heat pump loses efficiency as the outside temperature drops, and below a certain point it can't pull enough heat from the air to keep up alone. That's when the backup heat strips kick in, and those run on straight electric resistance, the same costly way a space heater does. On the coldest nights here, a heat pump working that hard can briefly cost more to run than a gas furnace would. How often that happens depends on your unit's size, its age, and how low Oklahoma's cold snaps actually run in a given winter.

A weathered gray outdoor condenser unit on a concrete pad beside a house with horizontal vinyl siding, with conduit, refrigerant lines, and an electrical disconnect box on the wall behind it.
Before you get your heat pump installation
A gray outdoor condenser unit on a concrete pad beside a beige vinyl-sided house, with a wall-mounted disconnect box, flexible conduit, mulch bed, shrubs and a concrete walkway in front.
After you get your heat pump installation

A heat pump works by pulling heat out of the outside air, and there's a point where that gets hard to do. Once it's cold enough outside, usually somewhere in the 25 to 35 degree range, the outdoor coil can't gather enough heat to keep the house at temperature on its own. That's when backup strips take over, heating the air directly the way a furnace does, at roughly the same rate per unit of power. Your savings over gas don't disappear on those nights, they just shrink while the strips are doing the work. The thermostat matters here too. Dropping it several degrees and then raising it fast asks the system for more heat than the heat pump alone can deliver quickly, so it calls in the strips even if the air outside isn't that cold. You might also notice the outdoor unit frosted over on a damp, near-freezing day. It will pause and run a short defrost cycle to clear the coil before going back to heating. How much of your winter runs on strip heat instead of the heat pump depends on how the system was set up for your house.

What happens on the coldest nights

  • Below about 25 to 35 degrees, your heat pump's outdoor coil can't pull enough heat from the air to keep up with the house.
  • A backup heat source, usually electric resistance strips, kicks in automatically to cover the gap on the coldest nights.
  • Those strips heat at close to a one to one rate, the same as a gas furnace, so your savings shrink while they're running.
  • A thermostat set too far down and then bumped up fast can trigger the strips unnecessarily, even on a milder day.
  • The outdoor unit may frost over in damp, near-freezing weather, then run a defrost cycle that briefly reverses the system to melt it off.
  • How often the strips kick in depends on how the system was sized and set up for your house, not just the weather outside.
A gray outdoor condenser unit on a concrete pad beside a house with horizontal lap siding, a conduit and disconnect box on the wall, a shrub with white flowers at right and evergreen foliage at left.
A clean coil pulls heat from the air the way it's supposed to, which is what keeps your cost below gas.
An outdoor air conditioning condenser unit with a top fan grille sits on a concrete pad beside a house with horizontal siding and a concrete step.
A coil caked in dirt and debris makes the unit work harder for less heat, and that's when gas starts looking cheap.
A smiling bearded man in a navy crewneck sweater sits at a dinner table with a glass of red wine, plates and glasses in the foreground, in a dimly lit room with a lamp and framed picture behind him.
A woman in a dark gray sweater reclines on a light sofa with eyes closed and a slight smile, under a textured gray blanket with an open book resting on her lap, with a lit table lamp and plant in the background.

No quotes to chase

Most of what decides your bill, the backup strips, the coil, whether the unit was sized right for your house, is easier to judge with eyes on it than over the phone. Finding that help usually means searching around, calling a few places, explaining the same setup each time, then sitting with quotes trying to tell one from another. That's the part this skips. Your request goes to one licensed contractor working in Oklahoma, someone who installs and services heat pumps in this market all year and has seen which ones hold up through a real summer here and which ones lean on strip heat more than they should come winter. You get one point of contact, not a week of fielding calls from five companies trying to win the job. Whatever you decide about your current setup, having someone local look at the actual unit beats guessing from a rule of thumb. The button above gets that started.

What you'd notice month to month

Your power bill carries the full load now, since there's no separate gas charge coming in alongside it. Most months that works in your favor, because the unit is moving heat rather than paying to burn fuel for it. The bill will still climb on the coldest stretches, when the backup strips are doing more of the work. If a month looks high, check whether a cold snap hit around then before you assume something's wrong with the unit itself.

Where the risk actually sits

Nothing about a heat pump failing looks dramatic. The house stays warm because the backup strips cover for a weak coil or a bad sensor, so a problem can run for months before the bill makes it obvious. By the time you notice, you've paid for it already, and the fix is the same either way. A furnace tends to show trouble faster, with noise or a smell. A heat pump just quietly costs you more.

Power costs 13.21 cents per kilowatt-hour statewide

At 13.21 cents a kilowatt-hour, your power bill has room in it for a heat pump to win out over gas. That rate is cheap enough that moving heat two or three times over, instead of burning fuel for it, still comes out ahead most months.

EIA-861 2025 statewide residential average

Where this leaves you

  • A heat pump costs less to run than gas heat in most Oklahoma homes, with power priced at 13.21 cents a kilowatt-hour.
  • Where it lands for you depends on the backup strips, the coil, and whether the unit was sized right for your house.
  • A contractor who works on heat pumps all season in your area knows which of those usually turns out to be the problem.
  • One local, licensed contractor looking at your actual setup tells you more than a rate comparison ever will.
  • You get one point of contact instead of several companies calling about the same job.
  • The unit itself, not the fuel it runs on, is what decides whether your bill backs up the answer above.

The answer to the question you typed in is yes, most of the time, at 13.21 cents a kilowatt-hour. That's the rate, and it's low enough that a heat pump moving heat instead of burning fuel for it comes out ahead of gas in most homes around you. But the rate only sets the odds. What decides your actual bill is the unit in your backyard: whether the coil is clean, whether the backup strips are kicking on more than they should, whether it was sized right when it went in. Two houses on the same rate can land in different places depending on those three things.

That's not something a phone call or a bill comparison settles. It takes someone looking at your actual setup, which is where a contractor who services heat pumps in your area through every one of these winters earns their keep. They've seen which of those three usually turns out to be the problem, because they're the one who gets the call when a heat pump's running up a bill it shouldn't be.

You'd be connected with one contractor, local and licensed, not a handful of companies working the same lead. That means one call, one visit, one person who looks at your coil and your strips and tells you straight whether your setup backs up the answer above, instead of five voicemails to sort through first.

An outdoor condenser unit on a concrete pad beside a dark horizontal-lap-sided house, with gravel, shrubs and a small electrical disconnect box on the wall, in dim light.

Skip the calls to every shop

The pro who reaches out is licensed in Oklahoma.

Step 1 of 3: Equipment